KES - G5 Compression Tester

Introduction to the Tester's Functions This tester simulates the sensation when a human fingertip touches an object. It can accurately test parameters such as compression hardness, compression work, and resilience. The tester has a detection function on the pressurization side, thus supporting various types of tests. Features - High - sensitivity measurement: The device can detect extremely small forces at the beginning of pressing down. - Detection of compression resilience: Even the resilience after pressing down, which is usually too small to be measured, can be detected by this device. Technical Parameters - Dimensions/Weight    - Device body: W170×D220×H460(mm)/13kg    - Electronic amplifier: W180×D400×H400(mm)/13kg, Power supply: AC100V, Maximum power consumption: 20W - Test environment temperature and humidity: 20～30°C/50～70%RH, without condensation. A certain temperature and humidity need to be maintained during the test. (Standard temperature and humidity conditions: 20°C/65%RH). ※It should be installed in a place less affected by wind and vibration. - Compression load test tester: Differential transformer (ring - type dynamometer). Load (full - scale range): Switchable among four ranges of 100gf, 200gf, 500gf, and 1000gf. Accuracy: Within ±0.5% of the full - scale range. - Compression deformation measurement tester: Potentiometer. Deformation: Up to 20mm. Accuracy: Within ±0.5% of the full - scale range. - Indenter area: 2 cm², circular (standard) - Compression deformation speed    - Standard test: 0.02 (mm / sec) <1mm/50sec>    - High - sensitivity test: 0.0067 (mm / sec) <1mm/150sec>. Other speeds can also be set as required.

- Specimen size (standard): Square, 2cm～10cm