Partition Wall Particle Flow Dryer

The heat transfer is indirect by heat conduction, and the heat exchange efficiency is high.

It can reduce the emission of dust and gas. When used as a heating and cooling device, the air will not directly contact the material.

The medium can be hot water, steam, thermal oil, etc. The heat source can be a dehumidification heat pump, air source heat pump, water source heat pump, gas boiler, biomass boiler, waste heat recovery, etc.; the moisture-carrying gas can be air or other inert gas.

The heat pump is used for energy recovery, high-quality drying of grain and economical and efficient thermal energy utilization. Since the system does not have any oxidative combustion process, there is no emission of CO2, SO2, NO2, and slag, which saves energy and reduces consumption, and has obvious environmental protection effects. Air is preheated, with strong moisture carrying capacity

Fully automatic intelligent control, continuous or intermittent discharge of materials with low breakage rate and no abrasion loss

Adopt indirect heating method to prevent secondary pollution of grain, high control accuracy, good drying uniformity, and improve drying quality

Using heat pump as heat source can save the transportation and storage of fossil fuels, no combustion, no open flame, greatly reduce risks, intelligent protection control, safe and reliable unit

Wide adaptability, long service life, and reduced overall cost

Modular assembly, easy installation